increasing water pressure blew up water softener
In message , Steve Walker
writes
wrote:
Hi,
I have or had a water softener fitted about 4 years ago. It was
comissioned at the time and I believe the pressure was below the
maximum limit of 70 psi or else it would not have comissioned by
the istallers (waterside)
While on holiday it leaked a large amount of water onto my kitchen
floor due to a fractured collar seal. The softener engineer
measured the pressure and it's now 100 psi , which is way above
the limit for this device.
You have mains pressure at 100psi, eg nearly 7bar?
That sounds extraordinarily high to me, but IANAP
I have exactly the same situation. Current pressure 100psi and
presumably less than 70 ten years ago.
I suspect the initial response to low supply pressure found in
multi-storey flats built on hill tops, is to jack up the system
pressure. Those living in valleys don't need to invest in pressure
washers.
regards
--
Tim Lamb
|