Colbyt wrote:
I need to cut a groove into the ends of a small section of in place
Hardwood flooring to accept the tongue of a perpendicular board. My
mind is on strike and rather than look at pictures of router bits for
a couple of hours I thought I would ask you guys for the name.

That's likely to be a problem. What you really need is a slotting or T&G
bit...problem is, many of them have a bottom bearing held on with a nut and
you wouldn't be able to cut a slot where you need it without taking up the
boards. You can get T&G bits without bearings but then would have to rig a
way to guide same along the edges at the proper distance from the edge.


--

dadiOH
____________________________

dadiOH's dandies v3.06...
....a help file of info about MP3s, recording from
LP/cassette and tips & tricks on this and that.
Get it at http://mysite.verizon.net/xico