"Shawn" wrote in message
m...
Hello,

I'm a newbie at home improvement, so please forgive my initial ignorance
when it comes to the technical terms.

I recently contracted with a nation wide vendor to install a central
air-conditioning unit in my ranch style home. This nation-wide vendor
sub-contacted with a local installer who performed the actual work during
May of 2004.

The blower was placed in the attic, with flexible duct work running to the
ceiling in various rooms. A large cold-air return was placed in the
central
hallway ceiling.

During the first year I had several problems with the installation. (These
included the blower drain that didn't function properly (causing ceiling
damage) and the cooling ducts separating from the vents in the ceiling.
These were repaired quickly and without question.

Fast-forward to today. I switch the unit on and realized that the unit
wasn't
cooling properly. I contacted the nation-wide vendor who dispatched a
heating and air specialist to my home. The specialist arrived and
proceeded
to tell me that the duct work that was attached to the blower unit had
"collapsed in-on-itself;" specifically where the flexible duct work met
the
intake end of the blower unit.

Apparently the original sub-contractor installer used semi-flexible foil
faced insulating sheeting to construct a connection from the flexible duct
work to the intake end of the blower. This same sub-contractor also
created
a large box (for lack of a better term) of this same semi-flexible foil
faced insulating sheeting and attached it to the ducts with foil tape.

So, my question(s) is this:

Is it typical to connect flexible 6" or 8" ductwork to a blower type unit
with 1/2"foil-faced insulation sheeting? In other words, isn't there some
type of reducer or pre-fabricated part that performs this function?

Since I have one large central cold-air return, is there any
pre-constructed
unit that should/could be installed in place of this taped amalgamation?
My
current setup is a 3' by 3' box that is surface mounted to my ceiling with
a
12" flex duct tube going from it to the cold-air intake of the blower.

Is there some type of building code that dictates what or how these type
of
constructions should be constructed as? Obviously, each town/area has its
own regulations, but what should I look for when researching?

Thanks,

Shawn



I have seen boxes (Return plenum) made of that foil faced insulation board.
I never thought much of them, but the ones that I saw were functional. The
best way that I know of is to have a sheet metal fabricator make a box to
the specifications that you need. You should make a drawing with multiple
view points and all of the dimensions. Include any openings for duct
connections. You can also have a filter compartment built into it. Take it
to a sheet metal fabricator and they can give you an estimate as to the cost
to make it. You can buy duct wrap and insulate it yourself.