No wrote:
First and Last wrote:
The granite installers cut the granite on both sides of the stove at
least an ich too short, so now the gap on the sides of the range are
bigger than they were with the old tile counters and I can see down the
unfinished sides of the cabinets.

Besides replacing the granite what can they do about that? The can't
add on to the granite without adding an ugly seam. What about adding
some kind of removeable decorative trim in these gaps on both sides of
the stove? I'd hate to delay finishing this for weeks while waiting
for new matching granite and having to redo the backsplash.
The backplash has already been partially installed. I had them delay
grouting the backplash until I'm sure these problems are fixed. If
there is no attractive fix to these gaps, the slabs will need to be
replaced and the backsplash partially redone.

One of the short slabs is seamed to an L connecting to another slab
with the new undermount sink in it. If they replace the short slab,
can it be cleanly removed and a new piece rejoined to the connecting
granite or will everything, including the other slab and installed
sink need to be replaced?

I cant envision the layout from your description. Would it be possible
to shimmy over the stove to one side, closing one gap, then move over
the other sides cabinet and top two inches to close the larger gap on
that side? Who measured? Them I assume.

Inviato da X-Privat.Org - Registrazione gratuita http://www.x-privat.org/join.php

they can seam it and it will be nearly invisible, if it was their
mistake then your within your rights to demand replacement.

i suggest you let them seam it then if its ok take some off the bill