Thread
:
Spindle nose adapter for Delta-Rockwell 11" lathe (#25-100) with L-00 spindle
View Single Post
#
2
Peter T. Keillor III
Posts: n/a
Spindle nose adapter for Delta-Rockwell 11" lathe (#25-100) with L-00 spindle
On 1 Dec 2003 10:48:56 -0800,
(Dan Allen) wrote:
I have a Delta-Rockwell 11" (#25-100) lathe and I'm looking for a
source for adapter sleeves for the L-00 spindle, which I believe has a
#4-1/2MT center hole. I'd like sleeves for #3MT and 5C collets as well
as a spindle nose protector. Anybody have any experience/advice
regrinding a #5MT to #4-1/2?
TIA,
Dan
Yes, don't. According to Royal, the taper is actually a short 5MT.
Put prussian blue on your 5MT and check. I got a 5C adapter from
Royal that works well for mine (same model). The part number is
R184024. I made my own spindle nose protector and drawbar. See
http://www.metalworking.com/DropBox/...oj-5CParts.JPG
and others in that series. My homemade adapter sleeve sucked, and was
replaced by the Royal unit. The rest is in service.
Pete Keillor
Reply With Quote