I live in Ontario and ahve to say that vapour barrier is really easy to put
up. Make sure that they also put some around all of the light and electrical
boxes to stop air movement. IT's hardly worth debating. BUT like another
post I'd use rigid foam if the basement has ever had water in it or urathane
spray foam.


wrote in message
oups.com...
Hi

I'm renovating the basement of an old house in Victoria, BC. The
climate here is typical Northwest. It rains a lot, but rarely does it
get below freezing.

The building code in this area says I should put vapor barrier on the
external walls between the drywall and the insulation. This is to
prevent in-house moisture from penetrating through the drwall and
insulation and condensing against the cold external walls. It's the
same building code across Canada.

My carpenter says however, that this code is relevant in climates like
Alberta where it gets to -10 and stays there for months on end, but
that for climates like BC where it hardly ever gets below freezing it
does more harm than good. His recommendation is that I not use vapor
barrier on the external walls and simply drywall right over the
insualtion. According to him, in temperate humid climates like British
Columbia, vapor barrier seals the moisture in the walls and causes more
wood rot and mold than without it.

(He does, however, recommend putting vapor barrier up against the
foundation (~ 2 feet) BEFORE the insulation and then drywalling. That,
he says, is to prevent the outside ground water moisture from coming in
through porous concrete and into the walls.)

What is your guys' opinion? Is he correct? Would you vapor barrier the
external walls between the insulation and drwall in humid climates that
rarely get below freezing?

Thanks for your thoughts.

Jack