On Thu, 20 Nov 2003 20:58:27 GMT, the renowned "Leo Lichtman"
wrote:


"Grant Erwin" wrote: It doesn't hurt anything.
Dremel sells a speed controller to do exactly this(clip)
^^^^^^^^^^^^
Well, not exactly. The speed controls used on AC
/DC tools like drills, routers, and the Dremel, cut down the width of the
on-time of each half-wave. This lowers the speed but does not lower the
torque much. A rheostat lowers the voltage, so as the speed goes down, so
does the torque. This probably does not matter if you're only filing the
toenails of a bird, but if you were using your Dremel for grinding or
carving, you would find the speed variation under load to be very annoying.

What makes a rheostat especially bad is that as you increase the load you
increase the current draw, which increases the voltage drop, further
lowering the speed and torque.

A variac works very nicely if you happen to have one. It lowers the
voltage without increasing the source impedance.

Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com