"Gary H" wrote in message
. com...
Hi. I have one of those Chinese mini-mills. I know it has its
shortcomings but I just tinker around in my garage so it is OK for me.
However, the gibs seem hard to adjust... but since I don't have a real
machine to compare it to, I don't know how bad it is. I would
potentially like to improve the gibs and adjustment screws if possible.
Could some one send a picture or describe how the gibs adjusters work on
a nice quality machine?

The Chinese mini-mill has gib strips with small dimples in them. The gib
adjustment set screws are pilot dog set screws that ride in those
dimples. Pretty simple. Unfortunately, for some reason, the gibs tend to
tilt and and having the entire gib strip act as a wear area. I hope that
makes sense and I look forward to hearing how the good machines do this.

Thanks,
Gary



Check out the guides on littlemachineshop.com
They have a new mini-mill user guide available for download.


Also this is a section on adjusting the gigs for the mini-lathe, but
it's the same manufacturer, so it might help:

http://www.mini-lathe.com/Mini_lathe...tm#adjust_gibs



--
Sending unsolicited commercial e-mail to this account incurs a fee of
$500 per message, and acknowledges the legality of this contract.