On 5 May 2006 19:52:52 -0700, "Jeremy Samuels"
wrote:

I'm working on a go cart as a school project with a friend. Our budget
is extremely limited, so we're leaning towards machining our own wheel
hubs. I have a HF minilathe, 1/2" drill press, and a 120v lincoln mig
with c25 and straight argon, so welding aluminum is possible. I'm
wondering what kind of accuracies would be required. Bolts will be at
a 4" circle, tire diameter of 6-8" at a speed of up to 25 mph, I'm
calculating 120 rpm (is that right?). Although this is kind of low,
I'm affraid the heavy radial loads may damage the bearings, especially
with no suspension. I'm confident I can hold 20 thou tolerances with
the setup I have now, but is there anything else I should consider?
I'm using the stock three jaw chuck, with HSS. I have a few boring
bars for the bearing. I don't have a rotary head or cross slide vise,
but have a wiggler.

An example can be found at
http://www.mfgsupply.com/m/c/53-681.html?id=XGPPnfW9

Forget about aluminum with the welder you have.

You'll want a lot better than 20 thou tolerance on a bearing housing.
You should be able to hold 1 thou with your minilathe over a short
distance like the depth of a bearing. Just take it slow, don't get in
a hurry, measure often, take more than one pass at a given setting
when boring because the bar (and the small lathe) will flex a little
until it's only skinning a thou or less.