On Sat, 22 Apr 2006 11:30:02 -0500, Don Foreman
wrote:

On Sat, 22 Apr 2006 16:12:50 GMT, "Keith Marshall"
wrote:



Look at the gauge on the low pressure side of your regulator. If it reads
CFH or SCFH you're in business. If it reads actual pressure you have the
wrong type.


You can use one calibrated in pressure. The MIG will have an orifice
inside that will set the flowrate as a function of pressure. Just get
a 1 qt baggie, adjust your regulator so the welder fills the
baggie with gas in about 6 seconds. That's about 20 cu ft /hr.

Don My hat is off!! In four lines of laymans lingo you have given
me a work-a-round for a gage setting that has been buggig me for quite
a while. sighgrin
THANKS much :-)
Bob


rgentry_at_oz_dot_net
_AT_ = @, _dot_ = . to eMail