Mark Main wrote:

John, as I re-read your note, I think that I did it backwards to what
you wrote. When I saw that I had continuity with what I had labeled as
A, B & C I deduced that these must be 4, 5 & 6 since these 3 are tied
together in the "low volt" diagram on the motor. But based on what you
wrote, I should have relabeled my A1, B2 & C3 as 4, 5 & 6 because A1,
B2 & C3 had continuity with 1, 2 & 3 respectively. and since you wrote
"tie the wires together that have continuity to 1 2 and 3" it sounds
like I need to swap my 4, 5 & 6 with 7, 8 & 9 respectively because I
did it backwards to what you wrote here.

the way it works is that the 7.8 and 9 wires are hooked up as a star
config. In the low voltage mode you create two parallel stars.
in the high voltage mode you add a series winding to each star, the
winding being 1,4 2,5 3,6 . In the low voltage mode you tie
4,5, and 6 together to get two star configs.


John