John, as I re-read your note, I think that I did it backwards to what
you wrote. When I saw that I had continuity with what I had labeled as
A, B & C I deduced that these must be 4, 5 & 6 since these 3 are tied
together in the "low volt" diagram on the motor. But based on what you
wrote, I should have relabeled my A1, B2 & C3 as 4, 5 & 6 because A1,
B2 & C3 had continuity with 1, 2 & 3 respectively. and since you wrote
"tie the wires together that have continuity to 1 2 and 3" it sounds
like I need to swap my 4, 5 & 6 with 7, 8 & 9 respectively because I
did it backwards to what you wrote here.