"eclipsme" wrote in message
. ..
Yes, Charlie. I have called - twice, in fact. The first time I was told to
loosen the bolt holding the lower and upper units together, and that this
would give me enough movement for adjustment.

It didn't.

I then called first thing yesterday. I was asked to take pictures and send
them. I created a web page showing how the blade is not square to the
table, and sent the technician the link. I have not heard back.

Here is the link:
http://www.eclipsme.com/bandsaw.htm


Doesn't look like they gave you any shim room on that bottom wheel, if I
interpret the picture correctly. It could use to go forward half the
straightedge gap distance, which would give you about twice the correction
to run that blade back to the crown.

Glad I have "old iron" in my shop.Without the blade, when you raise the
upper guard, does the deviation from vertical on a point on it display the
same displacement? If it does, could be that he's right, and it's a riser
block problem.