Trust the answer "But this should be a function of where you set the stop
on the drill, not the jig itself. "
"Tim Taylor" wrote in message
news
KA1g.905407$x96.892725@attbi_s72...
I know there is some pocket hole screw guys out there. I don't have the
Kreg tool, yet, but I've got a Taiwanese rip off. I got it from Rockler
about 6 years ago. What I'm wondering is, on the good Kreg, does it leave
the screw heads just a bit proud of the surface? By a bit, I'm talking
1/16th or so. I'm not really concerned about all but one piece I just did.
I have to do a dado after it's assembled. No big deal as I'll just grind
the screw heads flush. Just wanted to know if it's "normal" or not. TIA.