I never had any problem with sap on my chainsaw when I cut my pine trees
up into lumber with my chainsaw mill. Stacked the boards, and air
dried them for almost a year before building sheds with them.

They will actually cut better if you cut them green (my experience) than
after they were dry. The water in the wood would lube the saw and it
would cut faster, and keep the saw blade cooler. But the down side of
that is when you are handeling the boards right after cutting them, then
is when you will find plenty of sap on your gloves or hands.

The last trees I cut up were 18 - 20 inch in diameter with straight
trunk for about 20 feet before showing much taper.

As for it being better to cut them into boards or have them hauled away
and then buying already dry and milled lumber, is up to you. To put in
the work, as opposed to paying for someone else to do the work.

For myself, it has always been well worth the effort to cut my own. Big
trees like that gives many wonderful clear straight grain boards.

I can not speak for the carving value, for I never did that.

Zap


tillius wrote:
I've got 7 huge pine trees being felled this week on my property.

My questions a

1) how bad will the sap screw up my chainsaw mill if I resaw these into
planks?

2) will they be any better if I let them dry a while first.

3) I'm planning on using at least 1 section of nice clear trunk to
carve a cigar store indian. Should I let the wood dry first or whould I
carve while the wood is still greenl.

Is it even worth resawing them or should I just let the tree service
remove the trunks too?

Till