"T i m" wrote in message
...
Hi all,

Is there a gadget out there that would de-burr / put a 45 deg chamfer
on the end of a range of small diameter rods (say 2-10mm dia)?

Like a hand countersink tool would do for a range of small holes, this
*thing* would for rods?

Depending on the quantity and their lengths either a drill held in a vice,
or lathe if you have access to one, and a file, but if you have lots to do
it would be quite time consuming! Also the chamfers wouldn't be exactly the
same but this may not matter.

HTH

John