Questions about a riser block on a 14" bandsaw
"Toller" wrote in message
...
I just bought a 1hp Delta 14" band saw. I got a 1/2" 4tpi blade for it and
have been playing with it.
It resaws 6" of mahogany easily enough, but bogs down on 6" of oak. I
made lumber out of black locust firewood, but it struggled.
It would be great to install a riser and be able to deal with larger
pieces, but since it doesn't do 6" all that well, I can't see doing bigger
pieces.
I would appreciate some advice on this from someone experienced.
Will installing a riser block change it's performance on smaller pieces,
or will that be pretty much the same as it is now?
The black locust lumber is pretty neat; any reason it is not used?
You absolutely need fewer teeth per inch. Look for something in the 1.3 to
2 teeth per inch range. The blade you are using is too aggressive for thick
ripsaws.
|