On Fri, 24 Mar 2006 16:13:25 GMT, "Karl Townsend"
remove .NOT wrote:

JUST WHAT I"M LOOKING FOR!!!!

When can I come get it?

Karl


"jw" wrote in message
oups.com...
Large Fosdick drill press. I haven't measured exactly so most
measurements are estimations.

The table is about 30" square. I would say it is 24" spindle center.
Stands about 8' tall to the top. 8 speed belt drive machine. Table is
adjustable to yield at least 30" under the spindle. 12" spindle
travel.

MT3 with a Jacobs 18N chuck.

Currently has a 3hp 3ph motor, but that could be changed pretty easily.

Heavy. Dont' know but would guess it's around 1500lbs. It made a big
Case skidloader grunt, so it's in that neighborhood.

It's more drill press than what I need. I already have a nice 20". It
would be nice to hang on to, but it's an extra.

Located in SE MN. I would like to get $300 for it. Depending on where
you are, delivery may be possible(meaning if I happen to be going your
way in the next while I could bring it along).

Dont' have pictures yet, but going to try to get some taken this
weekend.

JW



One of these days I'm going to have to put a pic of the Cincinnati
Bickford 28" Super Service drill press I traded for. It's 3100lbs, #4
Morse taper, low of 60rpm, power feed, gear drive, 7 1/2HP 3phase,
etc. Sweet is all I can say about it. :-)