Robatoy and all,
Thanks for the replies, did you use a ready made router plate and then
set the plate in your homemade plate? Or did you just make the
homemade one and then drill it to fit your router? Where would my best
bet be to find some soild surface material to make the plate? My
router is a Porter Cable 692, 1 1/2hp with the "D" handle.
257roberts

Robatoy wrote:
In article .com,
"257roberts" wrote:

I just purchased a new Rigid TS2400LS Table Saw. I read when
researching the purchase, that a router table/plate could be added to
the saw. The saw table splits in half, making a hole that a router
mount of some sort could be added using the table saws existing fence
for the router also. The local Woodcrafters store has a predrilled
plate that will fit my router, but would need some other larger plate
to fit in the saw table. If you have ever seen anything like this
rigged up, please post back. Thanks so much.

I have that saw. I made a plate for it out of a rejected sink-cut-out
made from solid surfacing. You have to rabbet the front and back of the
plate so that the surfaces are level. Mine is pink..lol