Thread
:
Revised Router Question
View Single Post
#
2
Posted to rec.woodworking
Chris Friesen
Posts: n/a
Revised Router Question
wrote:
I need to dado a 3/4" width and 3/8" depth in oak plywood. I will be
using a 3/4" carbide tip straight bit with a 1/2" shank. Can I do this
in one pass? What speed should I set my router?
I wouldn't do it in one pass. That's a lot of wood. I also wouldn't use
a full-width bit, as generally speaking the stuff you're putting *into*
the dado isn't exactly 3/4".
Better to use one of the jigs posted earlier with a 1/2" bit.
As for speed, that depends on the specific bit. You might look at this
article:
http://www.newwoodworker.com/rtrbitspds.html
Chris
Reply With Quote