MIG welding with DC power supplies
Ignoramus2596 wrote:
I have a few power supplies PP-1104C that are rated 100 A at 14 VDC
and 50 A at 24 VDC.
OK... If I put two of them in series, I could get 100 amps at 28
volts. Would that be good enough for welding most stuff. I hope that I
am making sense, I am a little drunk at the moment (wife bday)
If you put the two in series you will have the combined voltages but the
current capacity of the smaller one.
--
Fred R
"It doesn't really take all kinds; there just *are* all kinds".
Drop TROU to email.
|