In message , Oliver Payne
writes
* mark :
Stripped it down and cleaned it (not that it was very dirty) and
measured the gap from the spark electrode to the surface of the burners
and set it the mid point of the range in my handbook.

Thanks, I'll have a look in the handbook. Any obvious gotchas with
stripping it down?

Not as I recall. I just remember it me thinking that it *had* to be
harder than it actually was. I guess you should be careful how you re
tighten the plate back on to the front.

I guess you should remember that the law say's you have to be
*competent* to fiddle with things gas.
--
mark