wrote in message
oups.com...
You know steve if you aren't interested in helping then don't post, its
as simple as that. Tony thanks for your interest in helping.


Get a short length of appliance power cord and cut about an inch of it off.
Then clean the coating off the traces you cut. Pull some strands of the fine
bare wires out of the 1 inch piece of cord. Use a small soldering iron and
"bridge" the cut traces with the wire. Cut off the excess. Using a decent
solder and some good soldering flux will make this a lot easier. Be sure you
have a good light and a magnifying glass to check your work. Clean the
repair with alcohol to get any remaining flux off. If you're real careful
you can clean the coating off the board and cut the excess fine wire with a
X-acto knife.

Al