DIYbanter - View Single Post

wrote:
Hello,

What's the proper technique for laminating two pieces of 3/4 x 5 x 36
inch maple? I surface and thickness planed rough stock down to 3/4,
brushed on a layer of Titebond to each face, mated them and clamped
along the length of each edge until the glue oozed out a bit. But when
it dried and I removed the glue beads I noticed that it did not mate as
close as I'd hoped for. What kind of rookie mistake did I make here?

Thanks!

Did you test clamping them together before you glued them up?