BIG edge jointing problem
Isn't is amazing how you can run a board over a device that has a cutterhead
flanked by two flat tables and get a board with a crown on the edge?
"noonenparticular" wrote in message
. com...
"Mike Berger" wrote in message
...
Wouldn't someone with a 12" table saw also be likely to have a
6" jointer, and wouldn't the jointer be a better solution?
hylourgos wrote:
Perhaps the OP can find someone with a 12" TS, or the Ryobi BT3K
series--they'll cut to nearly 4"
H
H,
I've a 6" jointer, but it's the standard JET 6" and when you take into
account the short (for this application) length of the table, the amount
of
effort it took to keep the timber pushed down on the top and up against
the
fence was prohibitive. Couldn't get an accurate cut.
Joe
|