Frank Ketchum wrote:

"noonenparticular" wrote in message
et...

Any ideas?

By the way, I'm going to use a full length 3/4" plywood spling during glue
up. Also, the gap on the edge at it's max is about 1/32, although most
spots are less or touch flush.



Could you mount the two boards with the 1/32 gap as is to a sacficicial
piece of plywood (use it as a sled) and rip it right down the joint on the
tablesaw? This would remove 3/32 (whatever your ts blade width is) and
should remove the gap.



I don't know about your TS, buy mine won't cut through 3-1/2" much less
that PLUS a sled. g (Notice the OP is joining the 3-1/2" edges)

Dave