"Frank Ketchum" wrote in message
hlink.net...

"noonenparticular" wrote in message
et...

Any ideas?

By the way, I'm going to use a full length 3/4" plywood spling during
glue up. Also, the gap on the edge at it's max is about 1/32, although
most spots are less or touch flush.


Could you mount the two boards with the 1/32 gap as is to a sacficicial
piece of plywood (use it as a sled) and rip it right down the joint on the
tablesaw? This would remove 3/32 (whatever your ts blade width is) and
should remove the gap.


You're saying to run both boards through at the same time, fastened to the
same sacrificial piece, right?

hmmmm..... That may work. Any error on one board is mirrored on the
other.....

Thanks Frank. I may give this one a go.

jc