Panel for kitchen cabinet doors
On Tue, 17 Jan 2006 23:03:07 -0600, "todd" wrote:
I'm in the process of building kitchen cabinets. I'm at the stage of
building doors and have a problem. I'm using a frame and panel design for
the door. The panel was intended to be 1/4" maple plywood. The rail and
stile cutter set I have cuts a groove expecting 7/32" (actual thickness)
plywood. This will come as a surprise to very few people, but the 1/4" ply
is well short of 7/32". I can think of some ways to keep the panel from
rattling around, but I'm curious about how other people deal with this
problem.
How bout a strip of veneer glued on the backside of the dado?
-Leuf
|