On Sun, 31 Aug 2003 01:02:04 -0700, mikee wrote:

Amen to the HSS route. Try facing 0.001 inch off a rifle barrel shoulder with a
carbide tool bit. Piece of cake with a sharp HSS bit, not so easy with one of
those through away carbide bits.

Mike Eberlein

Amen to that!

And I used to take off a couple of tenths sometimes too. It was
harder to measure the cut than it was to make it. I did the cut with
a specially ground 3/8" Mo-Max HSS cutting bit that I had that was
used for nothing else.



-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----