That's because you never fixed the problem
that caused those components to blow in the first place.


"Dani" wrote in message
oups.com...
KV-32S40 dead, replaced horiz output, MX regulator IC, & resistor. VDR
on separate power supply board measured open...should be ok, & I never
had that type VDR in stock, used the
variac, slowly up to 120 vac, after 30 secs...gently blew the parts
again. Replaced horiz drive
cap. Pix was perfect. Did I miss anything? Should I replace the VRD,
even though it measured open circuit? Thanks.