"Vass" wrote in message
...
"Nige" wrote in message
...
I need to bend some 22mm copper pipe into quite a wide radius curve -
is it possible to use conventional pipe benders to do this (the type
with long handles)?
It's just that from looking at them, they appear to have a fixed radius
former - or is there a way of increasing the radius of the curve you
make?
Above all, I need to produce smooth curves - is there a better way of
doing it?
Any advice would be appreciated...
get a pipe spring,
http://www.screwfix.com/app/sfd/cat/...12076&ts=74183
£ 1.99 then you can have any radius you like
Only as long as the length of the spring.