Thread
:
sheet metal gas engine project
View Single Post
#
11
Joe Kultgen
Posts: n/a
sheet metal gas engine project
In article ,
says...
On Tue, 26 Aug 2003 14:04:38 GMT, Joe Kultgen
wrote:
IIRC Franklin did this as well on their large diesels, especially the
ones that used both ends of the same cylinder. (Two crankshafts with
pistons compressing towards each other.)
You sure it wasn't Fairbanks-Morse? FM was famous for their OP.
I don't believe Franklin got involved with large diesels- just
air-cooled aircraft engines (except for the water-cooled Tucker).
-Carl (who lives about half a mile from the former Franklin plant).
You're right. That'll teach me to get involved in a diesel thread with
aircraft on the brain. :-)
Later,
Joe
Didn't PZL take over the Franklin line?
Reply With Quote