On Sun, 01 Jan 2006 17:30:52 GMT, Rebecca Paterno wrote:
I just put together my X5 6" jointer and am not sure if my fence is set up
properly. It's my first jointer, so I have no frame of reference when it
comes to fence operation.

There is a small tab that extends down from the fence on the outfeed side
just to the left of the cutter. The tab is only an inch or so wide. It
basically rests on the table and unless I lift and lock the fence into
place, it will scrape across the table when I move the fence back and
fourth. It seems like an awkward way for a fence to set up. This can't be
the way it operates?

Any suggestions??

My 8-inch X5 jointer has the same "feature". I was able to set the height of
the fence such that the tab does not touch the table.

--
Art