HI,
interesting, my 8904 doesn't have a filtered IEC and is also riveted. The
power supply board
clearly does have a filter, perhaps it's a change made sometime during
manufacture, my SN is 2923
is yours earlier or later? Perhaps a change, if your's is earlier, due the
problem you mention re the cracking of the connector?

The manual on the Agilent website is for SNs 27612 thru 2948

Cheers
Greg




"Mike Deblis" wrote in message
...
"gcd" wrote in message
...
Hi Mike,
the 8904A service manual is available for download from Agilent.

From what I see in my copy is that the connector is part of the loom W1
and
the connector is not identified seperately.

I just opened the top cover of mine and it's not a filtered connector.
These
usually have a a silver box on the back of them with the caps and
inductors.
From what I see , the filter is contained on the power supply board, a
large
X2 cap is there as well as inductor etc.

Having said that - is it a 8094a or a 8904a - 600kHz ARB? Your subject
says
8904a and your post says 8094a?

The 8904A has two caps on the power supply pcb just behind the IEC
connector, perhaps one of those?. These are after the bridge rectifier.

if it is the arb - does yours have any options apart from 1 & 3? If so
could
you list the code numbers on the label inside at the back for those
options.

Hi - thanks for the reply...

I removed the failed filter and can now see the p/n - its a Schaffner
FN326B-3/01 - the back has blown with all sort of oily gunk.

A new one from RS in the UK (Scaffner p/n FN 326-3/06) is about $7, so
I'll
just slip one of those in.

The unit is an 8904A Synth. Options 2 & 4... Everything seems to run ok.
Only problem removing the old one was that HP had pop-rivetted the
connector
to the back plate which had actually fractured the mount. Pretty poor,
really. Just used a reamer to remove the rivets, and all is fine - new one
will be fitted properly!

Thanks