Rebecca,

I don't have a Delta but on mine that tab has a small Teflon (plastic)
button that is stuck into a small hole on that tab. This Teflon is what
rubs on the table. I just checked the Delta site and both the Owners manual
and the Parts breakdown and neither shows the tab you're talking about and
there is no part listing showing a rub block either. My guess is that the
manual illustration is not showing all the details.

Bob S.


"Rebecca Paterno" wrote in message
news:glUtf.2718$tJ1.177@trndny01...
I just put together my X5 6" jointer and am not sure if my fence is set up
properly. It's my first jointer, so I have no frame of reference when it
comes to fence operation.

There is a small tab that extends down from the fence on the outfeed side
just to the left of the cutter. The tab is only an inch or so wide. It
basically rests on the table and unless I lift and lock the fence into
place, it will scrape across the table when I move the fence back and
fourth. It seems like an awkward way for a fence to set up. This can't
be the way it operates?

Any suggestions??