Bill, Thanks for getting back to me. I may look around for a couple of used
faceplates or buy new ones from shopsmith. I hate to see you tool up for one
customer. My thinking was that maybe you were set up for it.......but didn't
get enough requests to devote webpage space to it. I see used faceplates go
for more than new on ebay G. I have kicked around the idea of a shaft adt.
(they are readily available from a guy on the shopsmith 10er
usersgroup-yahoo). If I decide to go this route I will place an order with
you. Thanks very much.
Lyndell
"William B Noble (don't reply to this address)" wrote
in message ...
yes, I can make them, the real question is, can I make them cheap
enough to be attrative?? I have the right tubing and washers, but I
don't have a handy shopsmith to test them on. So, time for some
thinking - I can do a couple of things, it seems:

1. make an adapter for shopsmith to 1"X8TPI, and then you can use my
standard faceplates (I can also make an adapter to 1.24X8TPI, but
that's pretty big for a shopsmith). The advantage is that you could
use all sorts of accessories that will fit a Jet or any other
mini/midi lathe and quit worrying about special shopsmith stuff - I'm
guessing I could make these for somewhere between $15 and $30, and
then you could get the cheap faceplates.

2. I can make faceplates for the shopsmith, but I'm guessing that they
would cost at least $15 - is that competitive?

your thoughts please? My goal here is to make good quality
inexpensive stuff that saves turners $$$$ - so I tend to not go after
stuff that is already available at

On Sat, 31 Dec 2005 17:44:01 GMT, "Lyndell Thompson"
wrote:


"William B Noble (don't reply to this address)" wrote
in message ...
ok, for all you guys who got nice shiny lathes for Christmas, or any
other excuse - when you are ready to consider faceplates, (or a vacuum
chuck), feel free to visit my web site, www.wbnoble.com and look
around.
Bill

www.wbnoble.com

to contact me, do not reply to this message,
instead correct this address and use it

will iam_ b_ No ble at msn daught com


Bill, I don't see them on your website but...........can you make
faceplates
to use on a shopsmith? They are 5/8" smoothbore with allen setscrew. Just
figured it didn't hurt to ask.
Thanks Lyndell

Bill

www.wbnoble.com

to contact me, do not reply to this message,
instead correct this address and use it

will iam_ b_ No ble at msn daught com