"Guess who" wrote in message
...
On Fri, 30 Dec 2005 17:55:36 GMT, "Toller" wrote:

Unfortunately I screwed up in cutting the slots on the mating pieces and
the
spacing only worked with the plywood upside down, with the thin part on
top.
Normally I would have redone it, but this was for a project my son was
doing
for 6th grade

Who was doing the project, you say?

We were. He didn't do all the work, but he did some of everything; except
for making the lap joints in 1/8" x 1/8" stock.

If you ARE intending to teach him, then do it right, and mark matching
surfaces before routing.

But if it came out perfectly, why wasn't it right? Is there some higher
standard than looking and working properly?