On Tue, 27 Dec 2005 16:40:47 GMT, Toller wrote:
I agree it is probably not flat, but my straight edge says it is. I have
redone everything from scratch. One of the rails the table sides on was
off by a hair. I fixed that, but the end result is the same.

It is possible that the column is leaning under the weight of the carriage &
motor. If that's the case, a prefectly flat table cannot be adjusted to keep a
constand depth of cut at all possible blade locations. Have you tried
tightening up the column? If your model is like mine, there are two bolts on
the column that are a different color than the rest. Try tightening them just
a little. Too tight, and the column will become very difficult to raise and
lower.

--
Art