There may not be philips head screws on your model.

On my Kenmore Elite 110.2495 there are clips that hold
the control panel to the lid. You have to open the lid to
the washer and reach between the tub and the lid to a
spot underneath the front corners of the control panel.

You will feel a semicircular clip that holds the control
panel to the lid. Squeeze it and push the front of the
clip to the rear of the washer. Once it is squeezed
enough that corner of the control panel will come free
of the lid. Repeat for the other corner.

Once both have been released lift the control panel and
then rotate it back on the hinges you show on your photo.

Then follow the rest of the instructions at the washer_repair
URL given in the previous post.


wrote in message
ups.com...
First, put the screws you took out, back on. Now take a look at this
series of photos. As mentioned, the newer models have trim pieces over
the screws, but the screws are at the same place:

http://www.cheapapplianceparts.com/washer_repair.htm