"Ed Sirett" wrote in message
news
On Mon, 12 Dec 2005 21:51:50 +0000, carl897 wrote:


My linea 24 Central Heating is working fine.

Hot Water is only giving luke warm, temp. is at 34 degrees. but when
flow at tap is closed the temp shoots up to 90 deg. on boiler display.

I have checked:
The water pressure at mains
Motorised Valve

I have replaced:
domestic heat exchanger
thermister on main heat exchanger.
thermostat switch on main heat exchanger.
thermister near dhw heat exchanger.
non return valve on bottom right of dhw heat exchanger.
Also replaced the valve bobbin in diverter valve (bottom left, located
behind motorised valve).
Also replaced the water pressure switch, But have not touched the
adjustable plastic screw heads on this switch.

I have noticed that the 22mm pipe that connects to "Diverter Valve
Manifold" (main brass housing at bottom left) is very hot indeed, But
the Domestic Heat Exchanger (DHE) body is luke warm. And so is the Hot
water outflow pipe. As soon as the tap is closed, the temp shoots up to
90 and the DHE begins to get hot to same temp as main feed pipe.


You have replaced all the parts I would have thought worth replacing.

Does the heating flow pipe get very hot during DHW operation? If so then
the diverter valve may need to be looked at again.

Failing that then I think there must be a near blockage into or out of the
secondary heat exchanger.



I take it the flow rate is not exceeding the ability of the heat source?