Thread
:
Can anyone explain this?!
View Single Post
#
15
Posted to rec.woodworking
Doug Miller
Posts: n/a
Can anyone explain this?!
In article .com,
wrote:
With a fairly straight piece of lumber (esp. one 35" long), shouldn't I
be able to cut one flat side, then flip and rip without issue?
NO! With a "fairly straight" board as your reference edge, you can't do any
better than to get "fairly straight" results. If you want "perfectly straight"
results, you need to start with a perfectly straight board.
--
Regards,
Doug Miller (alphageek at milmac dot com)
It's time to throw all their damned tea in the harbor again.
Reply With Quote