On Thu, 31 Jul 2003 21:54:53 -0500, Jeepers
wrote:

I need a small brass screw to repair an old lighter. I'm sorta
"trolling" to find a source for one. it's 0.360" long with a shaft is
about 0.050" in diameter. Can someone point me in the right direction?

Heck, if you post the actual thread pitch, diameter and length,
somebody here on r.c.m can probably make you one. Or if you say where
you are, one of us nearby might be able to check those measurements
for you and you could pick one up at your local hardware store...

Al Moore