Yes it is!!!! All you have to do is turn the blade inside out.
Easy to do.

Jim

Siggy wrote:
It's not possible to install a correctly welded blade such that the teeth
are backwards. You only have two options - teeth up or teeth down. If the
teeth were down and pointed backwards the blade would have had to have been
welded backwards.

"mj" wrote in message
oups.com...

Hey Pete,
Sounds like yours is going pretty good. I got mine set up a couple of
weeks ago and the motor quit turning after not even two cuts. The first
was through a 1-1/2" brass bar and the second was just starting on a 3"
brass bar. I replaced that cheap motor with a heavier duty 1/2 HP
motor. I also replaced the blade in mine (that was the very first mod).
When I was taking the original blade out, I noticed the teeth were
backwards. Someone from the factory installed it wrong.
I haven't contact HF yet on the motor. I should probably do that this
week...
Mike