Thread
:
FA: Rivett 1020S Toolroom lathe - North Florida
View Single Post
#
11
jim rozen
Posts: n/a
FA: Rivett 1020S Toolroom lathe - North Florida
In article ,
inch says...
I've got Sjogren-Hardinge 2J and 3J chucks for my lathes. The 2J will go up to
1-3/8", and hence will pass through the Monarch's spindle. The 3J will do a lot
better, but only for short workpieces.
I've used the large one of those on a 10EE in the past, and it
is truly a nice setup. The only *real* problem with it, is
trying to pronounce it!
Shoe-Grain
Slo-Jog-Ren
Es-Jo-Gern
etc...
Jim
==================================================
please reply to:
JRR(zero) at yktvmv (dot) vnet (dot) ibm (dot) com
==================================================
Reply With Quote