"Fritz" wrote in message
oups.com...
My charger for my cordless drill recently stopped working. My drill is
dead as a doornail, and I've got projects pending. It's an off-brand
(Master Mechanic), and I've had some difficulty locating the
manufacturer. Efforts to purchase a new charger have gone nowhere.

So...I was able to determine that the fault lies with the AC/DC
converter ("wall-wart"). It's rated at 200mA and 14.5VDC, but at the
moment it's putting out essentially 0VDC (verified with my
multitester). I went to Radio Shack and purchased a 15VDC 1A wall wart,
with the intent of cutting and splicing it to the charger, but when I
tested it's output myself, it's actually kicking out 20.33VDC. This
seems high.

What happens if I solder a 20.33VDC output to a charger that's used to
operating with 14.5VDC? Will it damage the battery? Cause an explosion?
Other deleterious effects?

Radio Shack also had a (rated) 12VDC wall-wart. If it runs hot like the
15VDC version does, I might actually get pretty close to 14.5VDC. Would
that be a better idea? Do the outputs from these low-grade AC/DC
converters always vary that much from their rated output? And does
anyone sell converters that will match the OEM one fairly closely?

f

Did you measure the output voltage without a load connected? If so, measure
it with it's intended load, namely the charger.