"SAIL4EVR" wrote in message
oups.com...
Personally I wouldn't use a table saw for square cuts. For that I'd
move my material to a sliding compound miter saw. Unless the material
is less than 2ft or so you can't control it well on a table saw to get
accurate squre cuts.

Then you need a better saw. A quality saw with a good fence, can be very
accurate on large sized items. I can do 30" wide on my Delta with
Beisemeyer fence and be within 1/32. If I had the room for hte 50" fence,
I'd be able to do that also. On smaller pieces, I can be even more
accurate.