In article , Grant Erwin wrote:
Anyway, this thing came without the little insert that goes in the
hole in the table. It isn't too hard to figure out how to make the
part that goes in there, but I'm wondering about the slot.
Every one of them that I've seen was all beat up from contour cuts anyway.
Undoubtedly the easiest way to cut it would be to just use the bandsaw to
cut the slot.
--
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
Mike Graham | Metalworker, rustic, part-time zealot.
|
http://www.metalmangler.com| Caledon, Ontario, Canada