Rob Morley wrote:
In article . com,
says...
Little disappointed that I'm having to define a 'corner bead'.
Axminster and Trend both identifiy their router cutters as this.


http://www.trendmachinery.co.uk/prof...9%2F70X1%2F4TC

and


http://www.axminster.co.uk/product.a...r%20beed%20rou
ter&sfile=1&jump=0

Now the characteristic of both of these and others is that the
groove, or if you look at the picture of either of these, the bottom
section of the cutter, is square across and what I would prefer from
looking at some older mouldings, is that this is a V, rather than a
U, if you like.

There is no way I'm going to use a scratch block on facings round
four doors, and there is also the possibility that there is 200 ft
of pine to be moulded.

Can't you just make your own granny's tooth to cut the final bit of
the vee?

The way I see it now is he wants a raised 'V' so could you not use one of
these...
http://www.toolshopdirect.co.uk/tren...es/11_3hss.jpg

to give you this VVVV using correctly spaced marked lines down the
facing(architrave), or is this again not what your after?

--
Sir Benjamin Middlethwaite