Any Ideas?
On Tue, 15 Nov 2005 08:40:32 -0500, Proctologically Violated©® wrote:
More successive drilling, pray to goddamm god you drill *straight* and
fairly on-center so's you don't screw up the threads, and eventually "peel"
off what's left of bolt in the aluminum hole, mebbe clean out what's left
w/ a tap, at that point.
Get thee a set of left-hand twist drill bits for this job. The torque
and heat from drilling has backed out stuck bolts for me in this
situation. Worst case, you still have a hole, so you're no worse off
than with a right-hand drill bit.
But yeah, keep it straight. Make a guide to help with that, maybe?
See the threads here on PB Blaster, Kroil, etc, for the *next* time. g
anti-seize is made for this, isn't it? You know, the grey "jumping
grease" that gets on _everything_?
Dave Hinz
|