Robert11 wrote:
Hi,

Thanks for answering my chainsaw questions; appreciate it.
Brand new user with this, and Poulan manual is really poor.

Might I also ask, please:

a. What is this depth gage you refer to ?

The manual has a small diag with an arrow to "something" on the chain which
is called a "depth gage". I thought it was something that is part of the
chain that "also" rides in the bar groove ?

How is it used ?

Or, is there a separate tool that was supposed to come with the unit, called
a depth gage ?

b. How is the chain turned over to use the other sides that you mention.
Aren't all the cutters up, as they are now ?
Is the chain reversable, somehow ?

Thanks again,
Bob

---------------------------
In addition to draining the gas, give the saw a good cleaning. Remove
all covers, remove the chain and bar, clean the bar grooves using the
depth gauge that should have come with the saw, blow out the
chips/crud, clean the air filter..

When putting the chain back on,
turn the bar over to even out wear, either sharpen the chain or have it
sharpened. That gets it ready for use in the spring. Just add
fuel/oil mix and go.

Bill did a good explanation of filing depth gauges. They are the
little vertical things that stick up between each cutter.

The tool is a very cheap looking (and costing) u-shaped piece of
mettal. You lay it across the cutters, the depth gauge sticks up in a
slot and you file until the file doesn't take off any more metal. The
side pieces of the 'U' are a nice fit into the bar groove. Just slide
it along the groove a couple of times. You will be surprised at how
much gunk comes out.

You don't turn the chain over, just the bar. I do it every time I
remove the chain for whatever reason and for sure every few filings if
it hasn't been done for awhile.

You should get a chain file guide. 90% of chainsaw problems are due to
dull chain. It only takes a few minutes to file one once you learn the
procedure. Guides range from a simple file holder with a couple of
angles stamped into it that set set the depth for you up to ones that
adjust all the angles and hold them while you file the entire chain.
That is what I use. A good source of tools, chains and general chainsaw
equipment is

http://www.baileysonline.com

If you file on the bench, you can file both sides of the chain using
the same hand. Stupid as it sounds it does work. Just mount the saw
upside down in the vise. Stand next to the powerhead to file one side,
stand at the tip facing the power head for the other side.

Harry K